Dinstar FXS Bedienungsanleitung PDF herunterladen (Seite 17)

DAG Series User Manual

Dinstar Technologies Co., Ltd.

3.3.1 System Information

Figure 3-3-2 System Information

System information interface shows the run information and port group information.

Table 3-3-1 Description of System Information

MAC address

The device ID in HEX format. This is needed for ISP

troubleshooting. Note there are separate MAC addresses for the

WAN side and the LAN side.

Network Mode

Route mode or bridge mode, if it is bridge, WAN port display

Network, and the WAN port as same as the LAN port

WAN port

Show WAN IP address of equipment,.

DHCP mode:

The equipment acquires its IP address from the first DHCP server it

discovers from the LAN it is connected.

Static IP mode:

Configure the IP address, Subnet Mask, Default Router IP address,

DNS Server 1 (primary), DNS Server 2 (secondary) fields. These

fields are set to zero by default.

LAN port

Show LAN IP address of equipment. If network mode is bridge,

LAN port will no display.

DNS Server

IP addresses of primary DNS server

System Up Duration

Time elapsed from device power on to now.

Network Traffic Statics

Total bytes of message received and sent by network port.

Version Information

Includes: product mode, software version, hardware version and

built time etc.

Port Group Information

Show FXS / FXO port information

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 40 41

Keine Kommentare

Dinstar FXS Bedienungsanleitung Seite 17