Dinstar MTG600 Bedienungsanleitung PDF herunterladen (Seite 25)

MTG600 User Manual

21 / 57

SS7 MTP link description

Trunk No

It is consistent with foregoing “Trunk No” of SS7 trunk.

Link No

Equipment maximum support 2 signaling links, these two links share workload, when

one link fails, the other link will take over the load until restore from failure, and then

they will share the load again.

Signaling Link Code

If a signaling point has established several signaling links, then the code of each signaling

link will begin from 0.

E1/T1 Port No

Indicate which E1/T1 this link is established on, it is stipulated that such numbering is

carried out according to the physical position of E1/T1.

Channel No

Indicate time slot that link is established on. It is assigned to 1 or 16 for time slot, the

default is 16 time slot.

2.6.3 SS7 Circuit

Figure 2-6-5 SS7 Circuit

Figure 2-6-6 SS7 Circuit description

CIC (circuit identification code) is an important parameter of SS7 circuit. It should be confirmed

with service provider. If the CIC is mismatched, it will result in one-way voice communication.

SS7 Circuit Add

Trunk No

The “Trunk No.” here corresponds to the “Trunk No.” of SS7 trunk.

E1/T1 port No

Fill in the port number of E1/T1. Assign E1/T1 to selected SS7 trunk.

Start Channel

The start of SS7 channel trunk

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 56 57

Keine Kommentare

Dinstar MTG600 Bedienungsanleitung Seite 25